8. Notes for Use J030G
8.1 It is suggested to use a SIM card which can be charged by other phones.
8.2 Please check the balance in the SIM frequently to make sure there it can work properly.
8.3 Try to keep the vehicle in the covering area of GSM signals.
8.4 Keep the password secret. When the password is known by others, please change it in time.
8.5 In disarmed mode, when the key is used to open the door and start the engine, there is alarm. Armed by phone, the remote controls fail. Only disarmed by phone the car can be started. It is suggested to arm the car by remote control.
8.6 Before using the Remote Engine Start order, make sure the gear is in neutral position.
8.7 On the highway, it is dangerous to use Activate Immobilizer order. It is suggested to broadcast to the thief and give him several minutes before giving this order. The owner can check the car status by Check System Status first. Confirming the car is stopped, the owner can give this order.
9. Trouble Shooting
Many apparent malfunctions are caused by maladjustment and incorrect connection. If you encounter any troubles listed in the following table, please check and adjust according to the methods. Should the troubles still persist, contact the dealer.
|
Troubles
|
Methods of Checking and Adjustment
|
|
Remote controls fail.
|
Check the whether the car is armed by phone.
|
|
The dialer cannot dial any phone numbers.
|
Check whether the SIM card was plugged in when the power of mainframe is on.
|
|
The car cannot be started normally.
|
Check whether the immobilizer is activated.
|
|
When there is alarm, no phone call to the alarm phone numbers.
|
1. Check whether the alarm phone numbers are incorrect.
2. Check whether there is balance in SIM card.
|
|
When there is no alarm, the system call alarm phone numbers.
|
Check the sensitivity of the shock sensor, and adjust it to a moderate level.
|
|
When you use the dialer to dial a number, there is no voice in the speaker.
|
Check whether the connection plug is in correct place.
|
|
The central lock doesn’t work or is abnormal.
|
1. Check the actuator.
2. Check the wire, fuse.
3. Read the installation instruction and wiring connection for central lock.
|
|
The car cannot be started. /System give notice that it is started successfully, but the system is still trying to start the ignition.
|
1、 The hand brake test line is not connected properly.
2、 The lamp test line of engine is not connected properly.
|
|
The siren beeps all the time and cannot be released by remote control after this system is installed.
|
1. Check whether the wire is connected correctly.
2. Check whether the fuse of the mainframe is burned out.
3. Check whether the model of mainframe and that of remote control is the same.
|
|
Parked and armed, this system alarms when a truck or a cart passes by.
|
Check and adjust the sensitivity of the shock sensor.
|
10. Special Notice
As the signal from remote control of the car is transmitted via RF, the control distance of remote control may be affected by buildings, geography conditions, and weather sometimes.
Read the Operating Instruction and wiring connection carefully before the installation. Please make out electro circuit of car first.
The mainframe should be installed away from high temperature, humidity and other electronic items. Plug the wire plug into the mainframe, and wrap the wire top with a paste-tape. Please take out the control wires, such as power supply wire, ignition wire, and light wire, door open signal wire. If there is no door open signal wire, it is needed to install corresponding sensor switch.
The power supply wire should be installed after all other wires being installed. Please wrap all the connection point with pastern.
It is suggested that the antenna should be installed close to the windshield. Any antenna folding, cutting and grounding is prohibited.
The shock sensor should be pasted close to the car. Adjust the sensitivity to a good level.
If the remote control distance shortens and the LED on remote control is dim, please change the battery.
When battery of the remote control is low, please change it in time. Please choose high capacity alkaline battery. Pay attention to the anode and cathode of the battery. |
GPS System